Try getting someone to power cycle the switch. I'm presuming that you have written your previous config to flash.
Mark On 28-Jan-2011, at 9:15 AM, Mike wrote: > > I was doing some troubleshooting on my 2950g switch. The 'management > interface', is vlan1, and had an ip address and so forth in it I could reach. > Apparently, a stupid move was to go into config mode and type the following > > interface vlan 300 > > At that point, my telnet management session went away and the switch is no > longer reachable via management any longer, although otherwise continues to > function. I am sort of at a loss to understand what the problem is but would > love to know so a) I don't do it again and b) to know if there's a way to > recover from remote since it's (naturally!) in a very difficult to acccess > location, and having management access again would be helpful. > > Thanks. > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
