Both ping and telnet go out with the same source IP? No ip telnet source-interface in the config?
On Sun, Feb 20, 2011 at 2:14 PM, Rutger Bevaart <[email protected]> wrote: > On Feb 20, 2011, at 1:54 PM, Chris Evans wrote: >> Try pinging with a larger mtu? Rule that out first I would say. >> > > Thanks for the tip, but the MTU does not seem to be an issue. I can ping > end2end with an IP packet size of 1492... > > 7200a#ping vrf vpn-customer > Protocol [ip]: > Target IP address: Y.206 > Repeat count [5]: > Datagram size [100]: 1496 > Timeout in seconds [2]: > Extended commands [n]: y > Source address or interface: > Type of service [0]: > Set DF bit in IP header? [no]: y > Validate reply data? [no]: > Data pattern [0xABCD]: > Loose, Strict, Record, Timestamp, Verbose[none]: > Sweep range of sizes [n]: > Type escape sequence to abort. > Sending 5, 1496-byte ICMP Echos to Y.206, timeout is 2 seconds: > Packet sent with the DF bit set > !!!!! > Success rate is 100 percent (5/5), round-trip min/avg/max = 292/292/292 ms > > Also the BGP session is rock-solid. > > Regards > Rutger > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
