I have set the keepalives however am getting a peculiar problem as am trying to have two routes via two different tunnels.
However the up and down is beign detected but the routes are not going via the tunnel. Does having the same destination within the source of the tunnel have any effect on the tunnels Regards, Righa On Mon, Feb 28, 2011 at 10:27 AM, Aaron Riemer <[email protected]> wrote: > If you are using GRE look into using keepalives. > > > http://www.cisco.com/en/US/tech/tk827/tk369/technologies_tech_note09186a0080 > 48cffc.shtml > > Cheers, > > -Aaron > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Righa Shake > Sent: Monday, 28 February 2011 2:41 PM > To: [email protected] > Subject: [c-nsp] Tunnel Up and Down State > > Hi, > > Am having a problem where by my tunnel state is still up even though the > end > point is down. > > How do i set the tunnel such that when the end point is down then the > tunnel > state is also down. > > Regards, > Righa > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
