Hi all, Just for the archives the answer is to bridge the ATM PVC to a VLAN interface. Thanks to the offlist response to help me sort this out (Joe).
Eg interface ATM4/0/1.300 point-to-point pvc 1/300 bridge-domain abcd vbr-nrt 2048 2048 1 encapsulation aal5snap interface Vlan abcd ip vrf forwarding red ip address aaa.bbb.ccc.ddd www.xxx.yyy.zzz regards, Tony. --- On Thu, 23/6/11, Tony <[email protected]> wrote: > From: Tony <[email protected]> > Subject: [c-nsp] RBE on SIP-400 > To: [email protected] > Received: Thursday, 23 June, 2011, 10:14 PM > Hi all, > > I have some services from a carrier that are being hand off > as a PVC with routed bridge encapsulation - RBE (via an > STM-1). > > This is connected to a 7609 with SIP-400 & > SPA-4XOC3-ATM, running 12.2(33)SRD4. > > It would appear that the command "atm route-bridge ip" is > only supported on ATM cards in the SIP-200 (I have no > idea WHY this limitation !). > > I definitely require RBE to terminate the service as I have > tried it on an old 7204 and it worked fine with "atm > route-bridge ip" enabled on the interface. > > Does anyone have suggestions or workarounds to get this > working on the hardware I currently have in the 7609 ? > > > Thanks, > Tony. > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
