Hi Colby, Let me review your requirement which was sent in a separate email so that these features can be put in the roadmap.
Regards, -Waris -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Colby Glass Sent: Wednesday, July 27, 2011 4:27 PM To: Sigurbjörn Birkir Lárusson Cc: [email protected] Subject: Re: [c-nsp] ME3600X Netflow and WCCP? Thanks guys. Before posting, I noticed that it's listed in the unsupported commands of an older IOS, but not in the newer one. That gave me some hope. Though, none of the guides I saw listed anything for configuring WCCP or Netflow. The feature nav listed WCCP Version 2 though. It's not looking good. On Wed, Jul 27, 2011 at 5:59 PM, Sigurbjörn Birkir Lárusson < [email protected]> wrote: > I wouldn't trust that, you can configure stuff on the ME3600X that doesn't > actually work (or in fact do anything at all) in practice, you can even > configure stuff that is in the manual, and is supposed to work, but still > doesn't work ;) > > I turned on flow on a couple of interfaces, turned on top-talkers and got > nothing. I then setup netcat to listen to a UDP port, configured export > to send it, and according to show ip flow export it's not exporting > anything. > > It also doesn't bode well for the support that ip flow-export is in the > list of unsupported commands in the configuration guide, nor does the fact > that there is only one reference to wccp in the configuration guide and > that's under the traffic-classifier for the CPU traffic... > > Kind regards, > Sibbi > > Þann 27.7.2011 21:31, skrifaði "Jason Lixfeld" <[email protected]>: > > >On 2011-07-27, at 4:45 PM, Colby Glass wrote: > > > >> All, > >> > >> Does anyone happen to know if the ME3600 supports Netflow and WCCP? I > >>have a > >> customer considering them for the WAN edge and the docs/feature > >>navigator > >> are coming up somewhat ambiguous. > > > >I haven't tested it, but... > > > >systems02.151front71(config)#ip flow-? > >flow-aggregation flow-cache flow-capture flow-egress > >flow-export flow-top-talkers > > > >systems02.151front71(config)#ip flow-export ? > > destination Specify the Destination IP address > > source Specify the interface for source address > > template Specify the template specific configurations > > version Specify the version number > > > >systems02.151front71(config)#ip flow-export version ? > > 1 > > 5 > > 9 > > > >systems02.151front71(config)#int g0/1 > >systems02.151front71(config-if)#no switchport > >systems02.151front71(config-if)#ip route-cache ? > > cef Enable Cisco Express Forwarding > > flow Enable Flow fast-switching cache > > policy Enable fast-switching policy cache for outgoing packets > > same-interface Enable fast-switching on the same interface > > <cr> > > > >systems02.151front71(config-if)#ip wccp ? > > <0-254> Dynamically defined service identifier number > > redirect Set packet redirection options > > web-cache Standard web caching service > > > >systems02.151front71(config-if)# > > > >This is on 12.2(52)EY1 > >_______________________________________________ > >cisco-nsp mailing list [email protected] > >https://puck.nether.net/mailman/listinfo/cisco-nsp > >archive at http://puck.nether.net/pipermail/cisco-nsp/ > > -- Colby Glass Network Engineer http://blog.alwaysthenetwork.com _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
