It is ugly but you can use a vlan acl to capture on a remote span session then forward out a port that is connected back to the device for ERSPAN. Not pretty but this can be used for ERSPAN or MPLS forwarding.
LR Mack McBride Network Architect -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Andriy Bilous Sent: Thursday, January 12, 2012 6:24 AM To: Robert Hass Cc: [email protected] Subject: Re: [c-nsp] erspan for just one IP Depending on your hardware and topology you might be able to xconnect RSPAN session through your L3. RSPAN supports ACLs to filter monitored traffic. http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/span.html#wp1033684 * You can use output access control lists (ACLs) on the RSPAN VLAN in the RSPAN source switch to filter the traffic sent to an RSPAN destination. On Thu, Jan 12, 2012 at 3:44 AM, Robert Hass <[email protected]> wrote: > Hi > > Is any way to have ERSPAN (on Cat6500) where traffic is copied only > for one IP within VLAN. > Eg. VLAN400, IP 2.2.2.2 (where VLAN consist /16 subnet and 2k active > hosts) > > Robert > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
