It is my understanding that you put switchport access vlan XX
on the dot1q-tunnel port and this encapsulates all traffic coming in
there to that specified
vlan. (So it's basically an access port to the customer, which instead
of being a normal
access port it accepts ALL tagged frames (encaps them in vlan XX) and
shoves them out the other vlan XX ports
you have with dot1q-tunnel after unencap from vlan XX.
The port does not operate in trunk mode at all and thus will ignore any
trunk based commands.
Tunnel ports also don't work on certain modules. Which module are you using?
--
GloboTech Communications
Phone: 1-514-907-0050 x 215
Toll Free: 1-(888)-GTCOMM1
Fax: 1-(514)-907-0750
[email protected]
http://www.gtcomm.net
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
