If you want to do what you described you need a switch that supports
vlan mapping
(switchport vlan mapping 1-2 dot1q-tunnel 3) to filter only those vlans
you want into the
tunnel vlan.
Or are you suggesting that you want to use the port as a trunk and a
tunnel at the same time
where some vlans get tunneled and some go direct to the switch vlan FIB?
(I think this is
possible with selective q-in-q, but as the other poster said I believe
you need the ES
modules for the 7600)
--
GloboTech Communications
Phone: 1-514-907-0050 x 215
Toll Free: 1-(888)-GTCOMM1
Fax: 1-(514)-907-0750
[email protected]
http://www.gtcomm.net
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
