Dear Shake,
For un-channelized STM-4 SPA No you can't configure card to work as STM-1. It will only connect to other STM-4 ports as it can only generate STM-4 SDH frames. For channelized STM-4 SPA Yes you can by configuring sonnet controllers. Regards, Umair Saeed -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Righa Shake Sent: Friday, April 20, 2012 12:41 PM To: [email protected] Subject: [c-nsp] SPA-1XOC12-POS, Setup as STM1 Hi, I have the following card SPA-1XOC12-POS on a Cisco ASR. show int pos0/2/0 POS0/2/0 is down, line protocol is down Hardware is SPA-1XOC12-POS MTU 4470 bytes, BW 622000 Kbit/sec, DLY 100 usec, I wanted to know if the card can be configured to work as STM1. If so how the configuration is to be done. Regards, Shake Righa _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
