On 05/29/2012 11:49 PM, Jason Lixfeld wrote:
Hi Piotr,
Both linecards (including DFCs), chassis and power supplies were
replaced.
The only common element left is the Supervisor. The standby
Supervisor was replaced on a prior RMA, but there has been no
(obvious) indication on either the part of TAC or myself to suggest
the active Supervisor is somehow responsible.
The chassis was rebooted this most recent time and has cleared the
error and it hasn't resurfaced in the few days since, but that
doesn't give me much comfort.
It could easily just be a software bug; I'm a bit surprised TAC didn't
suggest such. Similar (but different) TCAM mis-programming errors were
endemic on early 12.2(33)SX releases on the 6500 (same hardware).
Do you have any upgrade/downgrade options available?
With regards deciding if hardware is faulty; have you run a full
(including all the disruptives) GOLD diag set?
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
