On 31/05/12 14:33, Jason Lixfeld wrote:
On 2012-05-31, at 9:02 AM, Phil Mayers wrote:
On 31/05/12 13:56, Jason Lixfeld wrote:
I've run:
'diagnostic start module<1-9> test all' to test all the modules.
All seem to have passed. Not sure if there are other diags to run.
At one point, those commands ran a sub-set of the diags; not sure if that's
changed in recent versions, but a full diag suite is (highly) disruptive to
traffic and (very) slow, so if you didn't see an outage, you haven't run them
all.
It shut the linecards down, so I'm pretty sure it did what it was supposed to :)
Cool, looks like they finally added the "all in one" command that was
lacking (you used to have the run the "big" tests manually in a certain
order, which was tedious).
If it passed a full diag, I think you're pretty safe on the hardware
front (unless it's a sporadic fault, like a loose solder joint, which I
hope is unlikely).
I would guess IOS bug at this point. Sadly :o(
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
