Mohammad, You are using two components that provide the same functionality which is to schedule work do be done in the future based on a CRON timer spec: 1. the IOS kron command 2. the Embedded Event Manager (EEM)
Use one or the other but not both. The CRON spec that you specified for the Embedded Event Manager timer of "* * * * *" says to run the EEM policy once per minute forever. If you want to cause the EEM policy to run once every 5 minutes beginning on the hour use a CRON spec of "0/5 * * * *". The CRON Expression section at http://en.wikipedia.org/wiki/Cron provides a good overview of CRON specs. Thanks, Clyde -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Mohammad Khalil Sent: Friday, July 20, 2012 4:21 PM To: [email protected] Subject: [c-nsp] Scheduled EEM Hi man , I have a question I want to do a command one time at a specific time I mean , for example after 5 min i will add a route after 10 min i will add another route and remove the older one and so I have configured the below , but it keep running PE1#sh run | sec event manager event manager applet MSSK event timer cron name KRON cron-entry "* * * * *" action 1.0 cli command "enable" action 1.1 cli command "configure terminal" action 1.2 cli command "interface fastethernet0/0" action 1.3 cli command "shutdown" kron occurrence KRON in 5 oneshot BR, Mohammad _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
