Put a real optical power meter on the fibers and adjust with pads as needed to get your levels within specs.
On 8/21/12 4:37 AM, "Patrick Cole" <[email protected]> wrote: >Marc, > >Perhaps it was right on the limit of max receive threshold and they >repaired a splice that was dodgy to start with increasing the signal. > >Patrick > > >Tue, Aug 21, 2012 at 11:13:48AM +0100, marc williams wrote: > > >> 10 GIG cisco compatible SFP in a 3750-X switch. >> we started to see this error message after a fibre break and repair: >> >> %SFF8472-5-THRESHOLD_VIOLATION: Te4/1/2: Tx power high alarm; >> Operating value: 0.6 dBm, Threshold value: 0.0 dBm >> >> Cant see how the TX power can go high? any ideas? Interface is up and >> working ok. >> >> -- >> Marc >> >> _______________________________________________ >> cisco-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ >> >_______________________________________________ >cisco-nsp mailing list [email protected] >https://puck.nether.net/mailman/listinfo/cisco-nsp >archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
