I have this working with roughly 35 megs of traffic to a Barracuda Web Filter. CPU on router is at 37% but I also run NAT on there. No issues.
Curtis LaMasters http://www.curtis-lamasters.com On Mon, Oct 15, 2012 at 1:55 PM, null zeroroute <[email protected]>wrote: > Anyone have any experience with running WCCPv2 on a Cisco 3825? > > The router will have two gig-e intertfaces, one will have a dozen or so > sub-interfaces, traffic routing from one physical interface to the other. > No routing protocols, no NAT, no IPSec, etc... just a simple router with > WCCP v2 enabled. > > I'm probably looking at average utilization somewhere around 50 Mbps, with > intermittent short lived spikes up to ~90 Mbps. Probably less then half > that traffic would be subjected to WCCP redirection, HTTP only. > > My only experience with WCCP has been on the 6500 platform with sup720-3b's > sending to some BlueCoat boxes and that's been running well, just wasn't > sure if there was anything to be concerned about with the level of traffic > noted above on a 3825. > > Any feedback is appreciated. > > Thanks, > > --NZR > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
