On 16 Oct 2012, at 10:12, Olivier CALVANO <[email protected]> wrote:
> Hi > > i have a small problems with a new Sup720-3B: > > When i start it, i have rommon .. at rommon, if i put "boot", he load > witout problems the IOS. > > > In IOS, i have added boot system flash disk0:xxx.bin but no change > in rommon, i have put "confreg" and select in boot "2" but no change > > any idea ? possibly the RP and SP config-reg are not the same or even set to go to rommon you can check with the following commands lab13#sh bootvar Configuration register is 0x2102 lab13#remote command switch sh bootvar Configuration register is 0x0 then fix it with lab13#conf t lab13(config)#config-register 0x2102 and the result lab13#sh bootvar Configuration register is 0x2102 lab13#remote command switch sh bootvar Configuration register is 0x2102 now should boot into IOS I have 1 sup720 in my lab that will not remember the config-reg on the SP if it gets powered off Steve _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
