Hi thanks for your answer but no change.
I see a possible problems in boot message: System Bootstrap, Version 8.1(3) Copyright (c) 1994-2004 by cisco Systems, Inc. Testing lower main memory - data equals address Testing lower main memory - checkerboard Testing lower main memory - inverse checkerboard Clearing lower 16K memory for cache initialization Clearing bss Clearing autoboot state machine Reading monitor variables from NVRAM Warning: Rommon NVRAM area is corrupted. Initialize the area to default values NVRam corrupted ? best regards Olivier 2012/10/16 Steve Lalonde <[email protected]>: > On 16 Oct 2012, at 10:12, Olivier CALVANO <[email protected]> wrote: > >> Hi >> >> i have a small problems with a new Sup720-3B: >> >> When i start it, i have rommon .. at rommon, if i put "boot", he load >> witout problems the IOS. >> >> >> In IOS, i have added boot system flash disk0:xxx.bin but no change >> in rommon, i have put "confreg" and select in boot "2" but no change >> >> any idea ? > > > possibly the RP and SP config-reg are not the same or even set to go to rommon > > you can check with the following commands > > lab13#sh bootvar > Configuration register is 0x2102 > > lab13#remote command switch sh bootvar > Configuration register is 0x0 > > > then fix it with > > lab13#conf t > lab13(config)#config-register 0x2102 > > > and the result > > lab13#sh bootvar > Configuration register is 0x2102 > > lab13#remote command switch sh bootvar > Configuration register is 0x2102 > > > now should boot into IOS > > > I have 1 sup720 in my lab that will not remember the config-reg on the SP if > it gets powered off > > > > Steve _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
