On 10/23/2012 1:40 PM, Jason Lixfeld wrote:
Hi all,

Running up against an odd issue where we have a 3550 with an LX GBIC trying to 
talk to a copper port on an ME3600 with a media converter in the middle.  The 
ME3600 side always shows as up; we disabled fault passthrough on the MC.  The 
LX GBIC on the 3550 side shows down/down with negotiation enabled, so with 
negotiation disabled, it shows up/up, but at half duplex(?!).  Anyone seen this 
before?  I didn't think an LX GBIC at half duplex was possible, even with 
negotiation disabled as there is still no way to force the duplex in that 
state.  Bad GBIC?  Media converter borked?  Gremlins?

I'd be grateful for any insight gleaned from prior experiences..

Thanks in advance.

For completeness:

Model number: WS-C3550-24-SMI
System image file is "flash:c3550-ipservicesk9-mz.122-35.SE5.bin"

TOYF-1.10-1.A920#show int g0/1
GigabitEthernet0/1 is up, line protocol is up (connected)
   Hardware is Gigabit Ethernet, address is 0014.6aa4.0c00 (bia 0014.6aa4.0c00)
   Description: Facing gi0-24.pe01.171EastLibertySt01.YYZ
   Internet address is 1.1.1.1/30
   MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
      reliability 255/255, txload 1/255, rxload 1/255
   Encapsulation ARPA, loopback not set
   Keepalive not set
   Half-duplex, 1000Mb/s, link type is force-up, media type is 1000BaseLX
   input flow-control is off, output flow-control is on
   ARP type: ARPA, ARP Timeout 04:00:00
   Last input 23:14:46, output 00:00:02, output hang never
   Last clearing of "show interface" counters 06:02:06
   Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
   Queueing strategy: fifo
   Output queue: 0/40 (size/max)
   5 minute input rate 0 bits/sec, 0 packets/sec
   5 minute output rate 0 bits/sec, 0 packets/sec
      0 packets input, 144492 bytes, 0 no buffer
      Received 0 broadcasts (0 IP multicasts)
      0 runts, 0 giants, 0 throttles
      0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
      0 watchdog, 0 multicast, 0 pause input
      0 input packets with dribble condition detected
      326 packets output, 122306 bytes, 0 underruns
      0 output errors, 0 collisions, 0 interface resets
      0 babbles, 0 late collision, 0 deferred
      0 lost carrier, 0 no carrier, 0 PAUSE output
      0 output buffer failures, 0 output buffers swapped out
TOYF-1.10-1.A920#sh run int g0/1
Building configuration...

Current configuration : 167 bytes
!
interface GigabitEthernet0/1
  no switchport
  ip address 1.1.1.1 255.255.255.252
  speed nonegotiate
end

TOYF-1.10-1.A920#show mac address-table int g0/1
           Mac Address Table
-------------------------------------------

Vlan    Mac Address       Type        Ports
----    -----------       --------    -----
TOYF-1.10-1.A920#

.........


TOYF-1.10-1.A920#sh int g0/1
GigabitEthernet0/1 is down, line protocol is down (notconnect)
   Hardware is Gigabit Ethernet, address is 0014.6aa4.0c00 (bia 0014.6aa4.0c00)
   Description: Facing gi0-24.pe01.171EastLibertySt01.YYZ
   Internet address is 1.1.1.1/30
   MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
      reliability 255/255, txload 1/255, rxload 1/255
   Encapsulation ARPA, loopback not set
   Keepalive not set
   Auto-duplex, Auto-speed, link type is auto, media type is 1000BaseLX
   input flow-control is off, output flow-control is on
   ARP type: ARPA, ARP Timeout 04:00:00
   Last input 23:18:01, output 00:00:18, output hang never
   Last clearing of "show interface" counters 00:00:32
   Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
   Queueing strategy: fifo
   Output queue: 0/40 (size/max)
   5 minute input rate 0 bits/sec, 0 packets/sec
   5 minute output rate 0 bits/sec, 0 packets/sec
      0 packets input, 0 bytes, 0 no buffer
      Received 0 broadcasts (0 IP multicasts)
      0 runts, 0 giants, 0 throttles
      0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
      0 watchdog, 0 multicast, 0 pause input
      0 input packets with dribble condition detected
      4 packets output, 1210 bytes, 0 underruns
      0 output errors, 0 collisions, 0 interface resets
      0 babbles, 0 late collision, 0 deferred
      0 lost carrier, 0 no carrier, 0 PAUSE output
      0 output buffer failures, 0 output buffers swapped out
TOYF-1.10-1.A920#sh run int g0/1
Building configuration...

Current configuration : 148 bytes
!
interface GigabitEthernet0/1
  description Facing gi0-24.pe01.171EastLibertySt01.YYZ
  no switchport
  ip address 1.1.1.1 255.255.255.252
end

TOYF-1.10-1.A920#

None of GBIC will do half duplex IIRC. And, they won't do subrate. The negotiate is there to appease the other end if it tries.

Can you try with a normal connect? My first thought is the converter. I have not met many over the years that I like (and that like me).

tv
_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

Reply via email to