Hi Guys,
Upgraded a 2960G to c2960-lanbasek9-mz.150-2.SE.bin and now the single mode SFP
wont link - Config is the same?
Other end of the fibre is a carrier switch, and they are seeing up/up:
Full-duplex, 1000Mb/s, link type is force-up, media type is 1000BaseLX SFP
We see down/down:
GigabitEthernet0/45 is down, line protocol is down (notconnect)
Hardware is Gigabit Ethernet, address is 0024.c3f0.912d (bia 0024.c3f0.912d)
Description: GIGE_ICAP_INTERNETCONNECT
MTU 1998 bytes, BW 10000 Kbit/sec, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Auto-duplex, Auto-speed, link type is auto, media type is 1000BaseLX SFP
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
