Hello,
vlan 850
int po 1
switch
switch mode trunk
switch trun allow vlan 850
int vlan 850
xconnect ...
I think it is what you could do.
Best regards,
Christohpe
Le 2013-01-04 10:36, [email protected] a écrit :
Hi
I have a Cisco 7301 with IOS:
(C7301-ADVENTERPRISEK9-M), Version 12.4(15)T1
This cisco is connected to my supplier:
interface Port-channel1
no ip address
interface GigabitEthernet0/1
mtu 1600
no ip address
duplex auto
speed auto
media-type gbic
negotiation auto
channel-group 1
On this link, we receive a Vlan: 850
I want sent by EoMPLS this Vlan to a another router,
on other router, without LAG, i use a traditional
interface GigabitEthernet0/1.850
encapsulation dot1q 850
no cdp enable
xconnect xxxxxxxx
But on LAG i don't know the process.
if i create a:
interface GigabitEthernet0/1.850
channel-group 1
no cdp enable
i have a error:
7301(config-subif)#encapsulation dot1Q 850
GigabitEthernet0/1 is a member of Port-Channel-1.
The intended configuration is not allowed.
and i don't have xconnect command
if i create a :
interface Port-channel1.850
encapsulation dot1Q 850
it's good for Vlan but i don't have a xconnect commande on
port-channel
what is the solution ?
best regards
Jerome
----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
--
Christophe Lucas
http://www.clucas.fr/blog/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
