Here is the output from "debug ppp negotiation". I'd say no one is responding on theo ther end.(??) Thoughts?
Jan 31 14:12:52.181 CST: %LINK-3-UPDOWN: Interface Serial0/1/0, changed state to up 000401: Jan 31 14:12:52.181 CST: Se0/1/0 PPP: Using default call direction 000402: Jan 31 14:12:52.185 CST: Se0/1/0 PPP: Treating connection as a dedicated line 000403: Jan 31 14:12:52.185 CST: Se0/1/0 PPP: Session handle[4F00000E] Session i d[9] 000404: Jan 31 14:12:52.185 CST: Se0/1/0 PPP: Phase is ESTABLISHING, Active Open 000405: Jan 31 14:12:52.185 CST: Se0/1/0 LCP: O CONFREQ [Closed] id 8 len 10 000406: Jan 31 14:12:52.185 CST: Se0/1/0 LCP: MagicNumber 0x60279E3E (0x05066 0279E3E) 000407: Jan 31 14:12:54.180 CST: Se0/1/0 LCP: Timeout: State REQsent 000408: Jan 31 14:12:54.180 CST: Se0/1/0 LCP: O CONFREQ [REQsent] id 9 len 10 000409: Jan 31 14:12:54.180 CST: Se0/1/0 LCP: MagicNumber 0x60279E3E (0x05066 0279E3E) 000410: Jan 31 14:12:56.196 CST: Se0/1/0 LCP: Timeout: State REQsent 000411: Jan 31 14:12:56.196 CST: Se0/1/0 LCP: O CONFREQ [REQsent] id 10 len 10 000412: Jan 31 14:12:56.196 CST: Se0/1/0 LCP: MagicNumber 0x60279E3E (0x05066 0279E3E) 000413: Jan 31 14:12:58.212 CST: Se0/1/0 LCP: Timeout: State REQsent 000414: Jan 31 14:12:58.212 CST: Se0/1/0 LCP: O CONFREQ [REQsent] id 11 len 10 000415: Jan 31 14:12:58.212 CST: Se0/1/0 LCP: MagicNumber 0x60279E3E (0x05066 0279E3E) 000416: Jan 31 14:13:00.228 CST: Se0/1/0 LCP: Timeout: State REQsent 000417: Jan 31 14:13:00.228 CST: Se0/1/0 LCP: O CONFREQ [REQsent] id 12 len 10 000418: Jan 31 14:13:00.228 CST: Se0/1/0 LCP: MagicNumber 0x60279E3E (0x05066 0279E3E) 000419: Jan 31 14:13:02.243 CST: Se0/1/0 LCP: Timeout: State REQsent 000420: Jan 31 14:13:02.243 CST: Se0/1/0 LCP: O CONFREQ [REQsent] id 13 len 10 000421: Jan 31 14:13:02.243 CST: Se0/1/0 LCP: MagicNumber 0x60279E3E (0x05066 0279E3E) 000422: Jan 31 14:13:04.259 CST: Se0/1/0 LCP: Timeout: State REQsent 000423: Jan 31 14:13:04.259 CST: Se0/1/0 LCP: O CONFREQ [REQsent] id 14 len 10 000424: Jan 31 14:13:04.259 CST: Se0/1/0 LCP: MagicNumber 0x60279E3E (0x05066 0279E3E) 000425: Jan 31 14:13:06.275 CST: Se0/1/0 LCP: Timeout: State REQsent 000426: Jan 31 14:13:06.275 CST: Se0/1/0 LCP: O CONFREQ [REQsent] id 15 len 10 000427: Jan 31 14:13:06.275 CST: Se0/1/0 LCP: MagicNumber 0x60279E3E (0x05066 0279E3E) 000428: Jan 31 14:13:08.291 CST: Se0/1/0 LCP: Timeout: State REQsent 000429: Jan 31 14:13:08.291 CST: Se0/1/0 LCP: O CONFREQ [REQsent] id 16 len 10 000430: Jan 31 14:13:08.291 CST: Se0/1/0 LCP: MagicNumber 0x60279E3E (0x05066 0279E3E) 000431: Jan 31 14:13:09.535 CST: %SYS-5-CONFIG_I: Configured from console by adm in on vty0 (192.168.2.138) 000432: Jan 31 14:13:10.307 CST: Se0/1/0 LCP: Timeout: State REQsent 000433: Jan 31 14:13:10.307 CST: Se0/1/0 LCP: O CONFREQ [REQsent] id 17 len 10 000434: Jan 31 14:13:10.307 CST: Se0/1/0 LCP: MagicNumber 0x60279E3E (0x05066 0279E3E) --- On Thu, 1/31/13, Jay Hennigan <[email protected]> wrote: > From: Jay Hennigan <[email protected]> > Subject: Re: [c-nsp] Cisco s0/1/0 T-1 is up but not showing up in route table > To: [email protected] > Date: Thursday, January 31, 2013, 11:45 AM > On 1/31/13 8:57 AM, false wrote: > > I cannot ping the far end. The int s0/1/0 output shows > up/up. The "sh service-module serial 0/1/0" output listed > below shows the T1 is up with the correct framing, > etc. The "sh diag" output below looks to be clean. > Here is the output for "sh int s0/1/0" as well. I am totally > at a loss here. Any ideas? Thank you > > > > sh int s0/1/0 > > Serial0/1/0 is up, line protocol is up > > Hardware is GT96K with integrated T1 > CSU/DSU > > Internet address is x.x.x.x/30 > > MTU 1500 bytes, BW 1536 Kbit/sec, DLY > 20000 usec, > > reliability 255/255, txload 1/255, > rxload 1/255 > > Encapsulation PPP, LCP Open > > Listen: IPCP, CDPCP, loopback not set > ^^^^^^^^^^^^^ > > This should be Open: IPCP > > What does the other end look like? Is its IP > configured correctly, > static address of the other side of the /30 ? > > What do you see with "debug ppp negotiation"? This > should give you a > hint as to where the problem lies. > > -- > Jay Hennigan - CCIE #7880 - Network Engineering - [email protected] > Impulse Internet Service - http://www.impulse.net/ > Your local telephone and internet company - 805 884-6323 - > WB6RDV > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
