weird, look what happens...
Feb 22 09:05:04: %PHY-4-SFP_NOT_SUPPORTED: The SFP in Te0/1 is not supported Feb 22 09:05:04: %PM-4-ERR_DISABLE: gbic-invalid error detected on Te0/1, putting Te0/1 in err-disable state Feb 22 09:05:04: local_port_disable for: Te0/1 xcvr-disable failed it doesn't show up in "show inventory" i bounce port and it comes out of err-dsbld but it still doesn't come up Feb 22 09:06:53: %LINK-5-CHANGED: Interface TenGigabitEthernet0/1, changed state to administratively down Feb 22 09:06:54: %SYS-5-CONFIG_I: Configured from console by vty0 (192.168.150.91) Feb 22 09:06:55: %LINK-3-UPDOWN: Interface TenGigabitEthernet0/1, changed state to down comparing the working tengig int in 0/2... only difference is SFP-ER is not seen on problematic one.... 3600#sh int ten0/2 | in Trans Transport mode LAN (10GBASE-R, 10.3125Gb/s), media type is SFP-ER 3600#sh int ten0/1 | in Trans Transport mode LAN (10GBASE-R, 10.3125Gb/s), media type is my field tech tells me that the sfp does have the cisco logo on it. (cisco tac on the phone looking up serial number right now) look what my collegue found on the internet... undoc command service unsupported-transceiver no errdisable detect cause gbic-invalid but this still doesn't make it work. i tried 2 different me3600 chassis and 2 different sfp's. same result. field tech using light meter sees NO LIGHT coming right off sfp me3600x running 15.3(1)S Aaron _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
