Hi,
Just an update to this - If I remove "switch virtual link " from the portchans,
and then re-apply them to the tenGig ints, the portchan comes up?
Portchan conf (That fails): (Hotmail will probably screw the formatting):
interface Port-channel5
switchport
switchport mode trunk
switchport nonegotiate
switch virtual link 1
And Int conf:
interface TenGigabitEthernet1/16 switchport mode trunk
switchport nonegotiate
no lldp transmit
no lldp receive
no cdp enable
channel-group 5 mode on
service-policy output VSL-Queuing-Policy
> Subject: Re: [c-nsp] 4500-X VSS %EC-5-CANNOT_BUNDLE2
> To: [email protected]; [email protected];
> [email protected]
> From: [email protected]
> Date: Fri, 8 Mar 2013 06:12:02 +0000
>
> 'sho run in te1/16'
>
> Sounds like you have dtp on it currently and it doesn't like that... Try
> defaulting the interface first?
>
>
> ------Original Message------
> From: CiscoNSP List
> Sender: [email protected]
> To: [email protected]
> Subject: [c-nsp] 4500-X VSS %EC-5-CANNOT_BUNDLE2
> Sent: Mar 7, 2013 9:39 PM
>
>
>
> Hi Guys,
>
> Following this guide: https://supportforums.cisco.com/docs/DOC-29472 and when
> trying to add the physical Int to the portchan, I get:
>
> %EC-5-CANNOT_BUNDLE2: TE1/16 is not compatible with PO5 and will be suspended
> (trunk mode of TE1/16 is dynamic, P05 is trunk)
>
> Config has been entered as per the above doc - Any suggestions as to why this
> is happening?
>
> Both switches are running:
> cat4500-e-ios-promupgrade-150-1r-SG7cat4500e-universalk9.SPA.03.04.00.SG.151-2.SG.bin
>
>
> Cheers.
>
>
> _______________________________________________
> cisco-nsp mailing list [email protected]
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
