We are using something like this on 5K. We have some VPC to monitor on pair of 5Ks.
monitor session 1 source interface port-channel1012 rx destination interface Ethernet1/40 no shut interface Ethernet1/40 switchport monitor Are you sure that vlan9 traffic actually flows through 5k(B)? >From your picture I see 4506 single-homed to 5k(A) only. If so, you might want to use RemoteSPAN. If 4506 dual-homed to both NXs via VPC you can monitor port-channels on both of N5K. Best regards, Victor Moiseev > -----Original Message----- > From: [email protected] [mailto:cisco-nsp- > [email protected]] On Behalf Of Scott Voll > Sent: Friday, April 05, 2013 2:31 AM > To: [email protected] > Subject: [c-nsp] SPAN on Nexus 5k > > I'm trying to setup a SPAN on a 5k and it's not working as I would have > thought. > > Topology: > > Servers on vlan 9 connected to 4506E <-10g-> 5k(A) <-Peer Link-> 5k(B). > > I'm trying to setup a monitor session on 5k(B) that monitors vlan 9 but > I'm > not getting any traffic. > > Vlan 9 is allowed on all the trunks. > > Am I missing something here? > > Thanks > > Scott > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
