Hi, The easiest way to do that is to use 'encapsulation default':
interface GigabitEthernet0/5 description Test INT VPLS switchport trunk allowed vlan none switchport mode trunk mtu 9000 load-interval 30 media-type rj45 service-policy output PM-INT-1G-OUT service instance 304 ethernet encapsulation default l2protocol forward service-policy input PM-CUST-DEFAULT-100M-BD-IN service-policy output PM-CUST-DEFAULT-100M-OUT bridge-domain 304 This configuration forwards all frames received on the physical port into a bridge domain (you can also forward it using a xconnect). kind regards Pshem On 30 October 2013 08:44, Aaron <[email protected]> wrote: > As MEF calls an l2vpn, private/port-based (which carries all, tagged or > untagged frames) that arrive at an interface.. EPL, EPLAN, EPTREE, I > understand the asr9k would implement this with. > > > > Int g0/0/0/0 > > L2transport > > > > With no encap needed. And then you would simply add that interface to the > xconnect group:p2p or bg:bd. > > > > Question, what is the interface config for doing this exact same thing on an > ME3600X ? > > > > Aaron > > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
