There is a limitation with shaping on a child policy on the line cards where the shaping rate on the "bottom" tier can't be above 128Mbps, as you have found out. I believe if you put both classes in the same parent policy you can get around it. For instance put your UDP shaper above the class-default class. Or maybe using commands other than shape like "bandwidth remaining."
Phil > On Nov 12, 2013, at 3:58 PM, "Aaron" <[email protected]> wrote: > > > (here's the uncommitted (failing) config... basically I want to shape > inbound UDP to 600 mbps. please show me how to accomplish that.) > > RP/0/RSP0/CPU0:eng-lab-9k-1(config-pmap-c)#show config > > policy-map from-internet-parent > class class-default > service-policy from-internet-child > shape average 1 gbps > ! > end-policy-map > ! > interface GigabitEthernet0/0/0/5 > service-policy input from-internet-parent > ! > end > > RP/0/RSP0/CPU0:eng-lab-9k-1(config-pmap-c)#commi > > % Failed to commit one or more configuration items during a pseudo-atomic > operation. All changes made have been reverted. Please issue 'show > configuration failed' from this session to view the errors > > RP/0/RSP0/CPU0:eng-lab-9k-1(config-pmap-c)#show config failed > > !! SEMANTIC ERRORS: This configuration was rejected by > !! the system due to semantic errors. The individual > !! errors with each failed configuration command can be > !! found below. > > interface GigabitEthernet0/0/0/5 > service-policy input from-internet-parent > !!% 'prm_ezhal' detected the 'warning' condition 'Cannot support child/flat > shape rate > 128Mbps' > ! > end > > RP/0/RSP0/CPU0:eng-lab-9k-1(config-pmap-c)#do sh run class-map > > class-map match-all udp-attack > match protocol udp > end-class-map > ! > > > > > -----Original Message----- > From: Oliver Boehmer (oboehmer) [mailto:[email protected]] > Sent: Tuesday, November 12, 2013 2:23 PM > To: Aaron; [email protected] > Subject: Re: [c-nsp] shaping > 128 mbps - asr9k > > > >> Anyone know how to accomplish shaping traffic at a rate greater than >> 128 mbps ? >> >> When I apply the policy-map/class-map to an interface it fails with >> this message. >> >> 'Cannot support child/flat shape rate > 128Mbps' > > can you please share the configuration you are trying to apply, including > policy-maps and where you want to apply this? > > oli > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
