Hi, Do you use the same RD for the default route on both of those originating PEs?
kind regards Pshem On 6 December 2013 07:09, Andrew K. <[email protected]> wrote: > I have a VRF configuration with MP-BGP/MPLS. > > In vrf A there are two default gateways being advertised to the > route-reflectors. > > Half of the PE devices in VRF A need to send traffic out one gateway and the > other half out the other, but the route-reflectors are only sending one best > route to the PE. > > Digging up info on add-path, it appears to have very limited support, I can > not find support for it using the feature set navigator for anything other > then the ASR1000, 7600, 3900 and IOS XR. > > Is this feature supported by the 7200? > > Can it be used in a VPNv4/VRF environment? > > Should I just be doing BGP Multipath Load Sharing instead and use a > route-map to set the weight of the default route for each PE device? > > Thanks in advance for your time. > Andrew. > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
