I do, but as Arie has pointed out I can simply trick the RR into sending
both routes to the PE.
PIC sounds great but we are using older hardware, I am not certain if
these features are support correctly.
On 12/5/2013 2:55 PM, Pshem Kowalczyk wrote:
Hi,
Do you use the same RD for the default route on both of those originating PEs?
kind regards
Pshem
On 6 December 2013 07:09, Andrew K.<[email protected]> wrote:
I have a VRF configuration with MP-BGP/MPLS.
In vrf A there are two default gateways being advertised to the
route-reflectors.
Half of the PE devices in VRF A need to send traffic out one gateway and the
other half out the other, but the route-reflectors are only sending one best
route to the PE.
Digging up info on add-path, it appears to have very limited support, I can
not find support for it using the feature set navigator for anything other
then the ASR1000, 7600, 3900 and IOS XR.
Is this feature supported by the 7200?
Can it be used in a VPNv4/VRF environment?
Should I just be doing BGP Multipath Load Sharing instead and use a
route-map to set the weight of the default route for each PE device?
Thanks in advance for your time.
Andrew.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
