Hello Rod, don't know if there is something special with RSP720 (or I do not understand the question), but this sounds to me like simple switching + a SVI:
int Gi1/x switchport switchport trunk encapsulation dot1q switchport mode trunk switchport trunk allowed vlan add <the vlans on that port> exit interface vlan1234 no shutdown ip address x.x.x.x <mask> exit kind regards Rolf > Hi > > I need to pass a couple of vlans from my switch trunk port to > another switch trunk both of which connected to my 7600 with RSP7203cxl. > Then from the same trunk port I have to get another vlan and assign an > ip address to that vlan. > > switchA -------*trunk*--------- 7600 ----------*trunk*-------- switchB > X,Y,Z | Y,Z > | > vlanX (ip address x.x.x.x) > > Looking around I see IRB, but its not supported in 7600s according > documentations. > > Hope someone could provide assistance or if it is even possible with my > current setup. > > Thanks! > > -- > *Rod Bio * > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
