Well in IPv6 you make use of ND to achieve this and stateless autoconfig There are different methods to autoconfig in IPv6 you may want to research this, like EUI-64 which makes use of the end systems mac address.
Jey S. Network Engineer CCIE #41608 Sent from my iPhone On 4 Jan 2014, at 19:49, M K <[email protected]> wrote: Thanks , I was wondering because i was following the configuration in the below document https://supportforums.cisco.com/docs/DOC-27714#Client_Configuration > From: [email protected] > Date: Sat, 4 Jan 2014 13:03:39 +0000 > Subject: Re: [c-nsp] DHCPv6 > To: [email protected] > CC: [email protected] > > You have to use : > > Ipv6 address autoconfig > > > Jey S. > Network Engineer > CCIE #41608 > > Sent from my iPhone > > > On 4 Jan 2014, at 12:17, M K <[email protected]> wrote: > > > > Hi I am trying to configure DHCPv6 , i am using c7200-adventerprisek9-mz.152-4.S2When I configure the server I found all the commands But when I configure the client I cannot find the command ipv6 address dhcp from interface configuration mode ?I enabled ipv6 unicast-routing > > _______________________________________________ > > cisco-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/cisco-nsp > > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
