Hi, I have seen in the config guides at way of send traffic in and out the same port or even different ports
http://www.cisco.com/c/en/us/td/docs/switches/metro/me3600x_3800x/software/release/15-3_1_S/configuration/guide/3800x3600xscg/swevc.html#wp1051612 I was looking to use the connect statement which seems to be there but maybe not supported?? Here is what I was trying interface GigabitEthernet0/5 description Local Connect Test switchport trunk allowed vlan none switchport mode trunk mtu 9216 load-interval 30 no cdp enable spanning-tree portfast spanning-tree bpdufilter enable spanning-tree bpduguard enable service instance 123 ethernet encapsulation dot1q 123 no rewrite ingress tag pop 1 symmetric no shut interface GigabitEthernet0/6 description Local Connect Test switchport trunk allowed vlan none switchport mode trunk mtu 9216 load-interval 30 no cdp enable spanning-tree portfast spanning-tree bpdufilter enable spanning-tree bpduguard enable service instance 123 ethernet encapsulation dot1q 123 no rewrite ingress tag pop 1 symmetric no shut ME1(config)#connect test gigabitEthernet 0/5 123 gigabitEthernet 0/6 123 %CONN: invalid segment 1 %CONN: Invalid Command ME1(config)# IOS is me360x-universalk9-mz.153-1.S1.bin. Have I done something wrong or is this not supported? Thanks Ivan _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
