Anyone know why this bvi stays up up even though there aren't any L2
interfaces/pw's up in this bridge-domain?
I would like the BVI interface to go down down when there are no underlying
layer 2 connections to be serviced.
This was the way ios switches have always operated. not sure why this isn't
acting the same.
Aaron
RP/0/RSP0/CPU0:9k#sh run l2v br gr v45
l2vpn
bridge group v45
bridge-domain v45
neighbor 10.101.12.250 pw-id 45
backup neighbor 10.101.12.251 pw-id 45
!
!
routed interface BVI45
!
!
!
RP/0/RSP0/CPU0:9k#sh l2v br gr v45
Bridge group: v45, bridge-domain: v45, id: 4, state: up, ShgId: 0, MSTi: 0
Aging: 300 s, MAC limit: 4000, Action: none, Notification: syslog
Filter MAC addresses: 0
ACs: 1 (1 up), VFIs: 0, PWs: 2 (0 up), PBBs: 0 (0 up)
List of ACs:
BV45, state: up, BVI MAC addresses: 2
List of Access PWs:
Neighbor 10.101.12.250 pw-id 45, state: down, Static MAC addresses: 0
Neighbor 10.101.12.251 pw-id 45, state: down, Static MAC addresses: 0,
backup
List of VFIs:
RP/0/RSP0/CPU0:9k#ibv1 bvi 45
RP/0/RSP0/CPU0:9k#sh ip vrf one int br bvi 45
Fri May 2 16:17:16.744 CDT
Interface IP-Address Status
Protocol
BVI45 1.2.3.3 Up Up
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
