On Oct 16, 2014, at 12:07 PM, Aaron <[email protected]> wrote: > SW_REV: 6.4.49T > MODEL: TM602G > Firmware Name: TS060449_102513_MODEL_6_TELNET_ON > Firmware Build Time: Fri Oct 25 15:06:46 EDT 2013
That version should support it, imo. You even have telnet access, apparently. Try running the CM in IPv6 first to see if it comes up properly (cable ip-init ipv6 under the cable interface). Some instructions are detailed there (but I guess you’ve seen this): http://www.cisco.com/c/en/us/td/docs/cable/cmts/config_guide/b_CMTS_Router_Layer3_BundleInterface/b_CMTS_Router_Layer3_BundleInterface_chapter_01.html There’s a MDD override MIB that has to be off (at “honor-mdd” actually) on the CM for this to work. Otherwise, posting your bundle config might help, but debugging IPv6 on a CMTS isn’t a small feat. For reference, this Live presentation isn’t bad either (it does have a focus on CNR however): https://www.ciscolive.com/online/connect/sessionDetail.ww?SESSION_ID=7934 JF _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
