Hi, I am trying to setup DHCPv6 accounting to sent start/stop records to a radius server however without success so far. TAC told me that apparently in IOS XE 3.13 this would be working but not in any previous version like IOS XE 3.7.x or 3.10.x according to their tests. We are currently on IOS XE 3.7.5 for our testing. The TAC engineer however cannot find any known bug or information describing this issue. below is the config I tested: aaa accounting delay-start all aaa accounting update periodic 120 aaa accounting network default start-stop group radius aaa accounting network RADIUS-GROUP1 start-stop group radius ! ipv6 dhcp pool SRV-P1 prefix-delegation pool IPV6-P1 lifetime 86400 86400 dns-server x.x.x.x.x.x.x.x dns-server x.x.x.x.x.x.x.x domain-name abcd.com accounting RADIUS-GROUP1 ! interface Virtual-Template1 ip unnumbered Loopback0 ip tcp adjust-mss 1452 peer default ip address pool IPV4POOL-DYN ipv6 unnumbered Loopback0 ipv6 enable ipv6 nd other-config-flag no ipv6 nd ra suppress ipv6 dhcp server SRV-P1 ppp mtu adaptive ppp authentication pap chap ! ipv6 local pool IPV6-P1 A:B:C::/42 56 ! radius server VO-Radius address ipv4 a.b.c.d auth-port 1645 acct-port 1646 key 7 xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx ! Is anyone running dhcpv6 accounting successfully on the ASR1k? If yes under which IOS XE version? regards, Christian
_______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
