Thanks also Sascha...did not know this was the case with the 2 outputs (received-routes shows all routes pre filtering, routes shows post filtering).
> From: [email protected] > To: [email protected]; [email protected] > Date: Tue, 10 Mar 2015 07:13:36 +0100 > Subject: Re: [c-nsp] Deny default route (From customer - BGP) > > received-routes show all routes even though they might have been filteres > out. Take a look at "show ip bgp neigh ... routes" > > Cheers > Sascha > > > > Am 10. März 2015 03:53:58 schrieb CiscoNSP List <[email protected]>: > > > Hi Everyone, > > > > Only had a few hours sleep, so I may be overlooking something extremely > > obvious...but we are receiving a default from a customer, even though > > route-map/prefix list *should* block it... > > router bgp xxx > > ... > > address-family ipv4 > > ... > > neighbor CUST_A route-map CUST_A-BGP-IN in > > > > ip prefix-list PL_DENY_DEFAULT seq 5 permit 0.0.0.0/0 > > ip prefix-list PL_CUST_A_BGP_PREFIXES seq 5 permit xxx.xxx.xxx.0/24 > > > > route-map CUST_A-BGP-IN deny 5 > > match ip address prefix-list PL_DENY_DEFAULT > > route-map CUST_A-BGP-IN permit 10 > > match ip address prefix-list PL_CUST_A_BGP_PREFIXES > > set community xxxxx:1400 > > > > Weird thing is, that "sh ip bgp summary" shows that neighbour as only > > having 1 in "State/PfxRcd" > > > > but "sh ip bgp nei xxx.xxx.xx.xx received-routes" shows the neighbour with > > 0.0.0.0 and there single /24 > > > > Cheers for any help. > > > > > > > > _______________________________________________ > > cisco-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/cisco-nsp > > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
