Hi, The same. You need something like ASR1k or something in the ISR range to do NAT. Depending on the SLAs with the service and amount of bandwidth you could consider something like a Raspberry PI (or other SoC) on a stick to do NAT as well.
kind regards Pshem On Tue, 29 Sep 2015 at 15:36 Aaron <[email protected]> wrote: > Thanks > > > > ASR920 ? > > > > Aaron > > > > *From:* Pshem Kowalczyk [mailto:[email protected]] > *Sent:* Monday, September 28, 2015 8:50 PM > *To:* Aaron; [email protected] > *Subject:* Re: [c-nsp] PE NAT / VRF Aware NAT on PE > > > > Hi, > > > > ME3600 does not support NAT. > > > > kind regards > > Pshem > > > > > > On Tue, 29 Sep 2015 at 14:46 Aaron <[email protected]> wrote: > > Anyone know how to do PE NAT / VRF Aware over MPLS L3VPN on an ME3600 ? > > > > I edge in ip traffic on ME3600's as the PE to MPLS L3VPN. > > > > I was wanting to make the customer-facing port of the ME3600 as the ip nat > inside port, but I don't know how / what would be the ip nat outside > interface since it's all mpls at that point. > > > > Anyone have a config or a link to a website explain the logic and config > behind this idea? > > > > Aaron > > > > > > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
