Hi All,
Can any share if a L2VPN ingress policing on a ME3600, is doing accounting at
L1 or L2 frame ?
(a) L2 Frame ( aka MEF service frame ) without the
"Inter-Frame Gap" and "Preamble & Start of Frame"
(b) L1 Frame ( aka 802.3 frame ) that is inclusive of
"Inter-Frame Gap" and "Preamble & Start of Frame"
Input is appreciated. Typical config is as follow.
Regards
Amos
interface GigabitEthernet0/1
description l2vpn:customer
switchport trunk allowed vlan none
switchport mode trunk
mtu 9178
no cdp enable
hold-queue 2000 in
service instance 1 ethernet
description l2vpn:customer
encapsulation dot1q 1000
rewrite ingress tag pop 1 symmetric
service-policy input CUSTOMER-QOS-IN-L2VPN-6M
service-policy output CUSTOMER-QOS-OUT-L2VPN-6M
bridge-domain 1000
interface Vlan1000
description l2vpn:customer
mtu 9178
bandwidth 6000
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
xconnect 223.28.0.41 5053 encapsulation mpls pw-class
eompls-interworking-ethernet
hold-queue 2000 in
end
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
