Hi Robert, we've finally received clarification from TAC: In our case this was a bug within IOS-XR 5.3.X. For us, this is fixed in 6.0.1 which we wanted to upgrade to anyway due to extended netconf support.
hth, Chris On Wed, May 25, 2016 at 5:05 PM, Robert Williams <rob...@custodiandc.com> wrote: > Chris - Thanks, I've not yet opened one, but would be curious to hear the > outcome of yours as it may save doubling up. > > Jimmy - If I take the sampling to 1:1 then yes I can achieve this event, > however, we appear to be at the limit of the 'exporter' not the > 'monitor/cache' so at present the cache is not being exceeded. > > Cheers guys! > > > > Robert Williams > Custodian Data Centre > Email: rob...@custodiandc.com > http://www.CustodianDC.com > > -----Original Message----- > From: cisco-nsp [mailto:cisco-nsp-boun...@puck.nether.net] On Behalf Of > Jimmy > Sent: 23 May 2016 17:16 > To: cisco-nsp@puck.nether.net > Subject: Re: [c-nsp] A9K Netflow export drops > > Hi, > Just wondering, > Did you find something like this on your syslog ? > %MGBL-NETFLOW-6-INFO_CACHE_SIZE_EXCEEDED : Cache size of 1000000 for > monitor xxx has been exceeded > > Regards, > Jimmy Hng. > > > On Tue, May 24, 2016 at 12:02 AM, Robert Williams <rob...@custodiandc.com> > wrote: > > > Hi, > > > > Doing some more digging, found this from 2014: > > > > Netflow specific scale and Limitations are described below: > > 1. Supports configurable Sampling Rate 1:1 ~ 1: 65535 > > 2. Supports only up to 4 Sampling Rates (or Intervals) per Ethernet > > LC LC; no such limit for Enhanced Ethernet LC. > > 3. Up to 4k interfaces/sub-interfaces (4K system limitation) can be > > configured with flow monitor per system. > > 4. Supports up to 8 flow exporters per flow monitor > > 5. Supports up to 1 million flow entries per LC > > 6. Supports up to 50k flows per second with LC CPU usage up to 50% > > per Ethernet LC LC > > 7. Supports upto 100K flows per second with LC CPU usage up to 50% > > per Enhanced Ethernet LC LC > > 8. Netflow scale is increased to 200Kpps on Enhanced Ethernet LC > > based LCs > > 9. Supports exporting packet rates up to 50k flows per second (100K > > flows per sec on Enhanced Ethernet LC based LCs) with LC CPU usage up > > to 50% > > > > "Irrespective of the rate at which the NP punts the records to CPU, > > exporter picks up a maximum of 2000 records at a time from the cache > > that are eligible for export (timers, network/TCP session events, > > etc). This is basically to avoid NetIO dropping the packets due to > > lack of b/w. When the exporter wakes up again, it repeats the same." > > > > So, it can collect 100k flows per second, but can only export 2k each > > time it runs the exporter. The interval for the exporter is unclear > however. > > > > I've also found out why this is such an issue on our 9001 but not on > > any of our 900x larger chassis. Looks like on those the hardware punt > > is being limited to 25kpps per NP because we have some BVIs with Netflow > on them. > > This causes it to distribute the rate limit for punting to ALL the NPs > > on the LC, even when only two ports are involved in Netflow. Thus, > > it's "sampled sampling" and so the rate of flow data is significantly > > lower than the 9001 which is allowing all 100kpps on one NP which has > > 4 x 10G interfaces punting into it. > > > > mmm... > > > > > > > > Robert Williams > > Custodian Data Centre > > Email: rob...@custodiandc.com > > http://www.CustodianDC.com > > > > -----Original Message----- > > From: Dale W. Carder [mailto:dwcar...@wisc.edu] > > Sent: 23 May 2016 16:02 > > To: Robert Williams <rob...@custodiandc.com> > > Cc: cisco-nsp@puck.nether.net > > Subject: Re: [c-nsp] A9K Netflow export drops > > > > Thus spake Robert Williams (rob...@custodiandc.com) on Sat, May 21, > > 2016 at 10:59:50AM +0000: > > > > > > I've got an issue on one of our smaller 9001 boxes which is puzzling > me. > > > It suffers from a high rate of netflow export drops (not cache > > > drops) > > shown here: > > > > > > So from what I understand, it is capturing the flows OK but is > > > unable to > > get the flow data out, for some reason. > > > > I can confirm that our 9k's suffer from this also. > > > > The last I checked you can export at the rate of 2000 flows/sec. I > > have not looked in 2 years or so to see if this limit was configurable > > yet. > > > > > So - what am I missing here? Surely with a cache capability of 1M it > > should be ok to export flows when were are only around 30,000 of them > > nicely ticking over? > > > > join the club. :-( > > > > Dale > > _______________________________________________ > > cisco-nsp mailing list cisco-nsp@puck.nether.net > > https://puck.nether.net/mailman/listinfo/cisco-nsp > > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > > _______________________________________________ > cisco-nsp mailing list cisco-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/