Hi all, > Am 19.05.2018 um 18:52 schrieb Lee <[email protected]>: > It's been several years since I've seen a 6500, but I doubt things > have changed. There's two boot registers on the 6500 - the switch > processor and the route processor. The switch boots up first and then > hands off to the route processor, so under normal circumstances > show boot > shows the boot variables for the route processor & [maybe not the > correct syntax] > remote command switch show boot > shows the boot variables for the switch processor. > > So if the SP confreg = 0x0 when the box reboots it stays in rommon > even if the RP confreg = 0x2102
Thanks for reminding me that this platform acts a bit schizophrenic at times ;-) And of course you nailed it. Standby chassis switch processor: Configuration register is 0x2100 (will be 0x2102 at next reload) I think it's pretty odd that a controlled reload is required to save the new setting. We did that in a maintenance window and now all 4 registers of our VSS are set to 0x2102. Thanks Patrick -- punkt.de GmbH Internet - Dienstleistungen - Beratung Kaiserallee 13a Tel.: 0721 9109-0 Fax: -100 76133 Karlsruhe [email protected] http://punkt.de AG Mannheim 108285 Gf: Juergen Egeling _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
