Hi I have PABX running CUCME and 79xx IP Phones (SCCP firmware). Traffic to PSTN is done by H.323 dial-peer to other our Cisco in HQ. HQ Cisco gateway have SIP Trunk to our carrier. Dial-peer to carrier have applied outgoing translation where we add 4345# prefix to called number.
My problem : when I calling outside called number displayed on the phone is changed to prefix - 4345#. I don't see called number but just prefix. Is any way to change this behavior ? My configuration: (dial-peer from HQ router to carrier) voice translation-rule 4000 rule 2 /^0)/ /4345#/ type any international plan any isdn ! voice translation-profile ADDPREFIX translate called 4000 ! dial-peer voice 1003 voip translation-profile outgoing ADDPREFIX huntstop destination-pattern 0T progress_ind setup enable 3 session protocol sipv2 session target ipv4:x.x.x.x:5060 dtmf-relay rtp-nte codec g711ulaw clid strip name no vad ! (dial-peer between CUCME and HQ) dial-peer voice 1000 voip huntstop destination-pattern 0T progress_ind setup enable 3 session target ipv4:10.4.30.2 dtmf-relay h245-alphanumeric codec g711ulaw ip qos dscp cs5 media clid strip name no vad
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
