Have we tried without #, as that might be treated as end of dialled string On 03-Feb-2014 9:16 pm, "Robert Hass" <[email protected]> wrote:
> Hi > I have PABX running CUCME and 79xx IP Phones (SCCP firmware). Traffic to > PSTN is done by H.323 dial-peer to other our Cisco in HQ. HQ Cisco gateway > have SIP Trunk to our carrier. Dial-peer > to carrier have applied outgoing translation where we add 4345# prefix to > called number. > > My problem : when I calling outside called number displayed on the phone > is changed to prefix - 4345#. I don't see called number but just prefix. > > Is any way to change this behavior ? > > My configuration: > (dial-peer from HQ router to carrier) > > voice translation-rule 4000 > rule 2 /^0)/ /4345#/ type any international plan any isdn > ! > voice translation-profile ADDPREFIX > translate called 4000 > ! > dial-peer voice 1003 voip > translation-profile outgoing ADDPREFIX > huntstop > destination-pattern 0T > progress_ind setup enable 3 > session protocol sipv2 > session target ipv4:x.x.x.x:5060 > dtmf-relay rtp-nte > codec g711ulaw > clid strip name > no vad > ! > > (dial-peer between CUCME and HQ) > > dial-peer voice 1000 voip > huntstop > destination-pattern 0T > progress_ind setup enable 3 > session target ipv4:10.4.30.2 > dtmf-relay h245-alphanumeric > codec g711ulaw > ip qos dscp cs5 media > clid strip name > no vad > > > _______________________________________________ > cisco-voip mailing list > [email protected] > https://puck.nether.net/mailman/listinfo/cisco-voip > >
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
