I am having problems configuring a CISCO 3825-CCME/K9 with 2 VIC-4FXS/DID cards and a 16 port POE switch NM-16ESW-PWR
IOS 12.4 We are configured with SCCP, H.323 I can make voice calls on all phones PSTN and VOIP however, when I attempt to transition to a secure call using a STE on a PSTN port the call drops after ~ 30 Sec. Any suggestions would be appreciated. aaa new-model ! aaa authentication login default local aaa authorization exec default local common voice-card 0 dspfarm dsp services dspfarm voice service voip fax protocol cisco modem passthrough nse codec g711ulaw modem relay latency 100 modem relay sprt v14 receive playback hold-time 35 interface Loopback1 description CME_Address ip address xxx.xxx.xxx.xxx 255.255.255.255 h323-gateway voip interface h323-gateway voip bind srcaddr xxx.xxx.xxx.xxx sccp local Loopback1 sccp ccm xxx.xxx.xxx.xxx identifier 1 version 3.1 sccp ! sccp ccm group 1 bind interface Loopback associate profile 1 register CME_DSP dspfarm profile 1 transcode codec g729abr8 codec g729ar8 codec g711alaw codec g711ulaw codec g729r8 maximum sessions 7 associate application SCCP control-plane voice-port 0/0/0 voice-port 0/0/1 no battery-reversal voice-port 0/0/2 voice-port 0/0/3 voice-port 0/1/0 voice-port 0/1/1 voice-port 0/1/2 voice-port 0/1/3 ip access-list extended VOIP-TCP permit tcp host XXX.XXX.XXX.67 any permit tcp any host XXX.XXX.XXX.67 permit tcp host 100.1.1.1 any permit tcp any host 100.1.1.1 ! ip access-list extended VOIP-UDP permit udp host XXX.XXX.XXX.67 any permit udp any host XXX.XXX.XXX.67 permit udp host 100.1.1.1 any permit udp any host 100.1.1.1 dial-peer voice 5139 pots description STE PSTN destination-pattern XXXXXX5139$ incoming called-number XXXXXX5139 port 0/0/0 _______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
