Hi Henry, Have you resolved this? I have also seen issues with STE's going secure as well, whether it be direct on the router as you have below, or any other setup, even though all devices are setup and calls go thru just fine.
-Bill -----Original Message----- From: cisco-voip [mailto:[email protected]] On Behalf Of AKIN, HENRY D JR CTR USAF AFGSC AFGSC/A7XN Sent: Thursday, July 10, 2014 5:27 PM To: [email protected] Subject: [cisco-voip] CISCO VOIP/PSTN STE I am having problems configuring a CISCO 3825-CCME/K9 with 2 VIC-4FXS/DID cards and a 16 port POE switch NM-16ESW-PWR IOS 12.4 We are configured with SCCP, H.323 I can make voice calls on all phones PSTN and VOIP however, when I attempt to transition to a secure call using a STE on a PSTN port the call drops after ~ 30 Sec. Any suggestions would be appreciated. aaa new-model ! aaa authentication login default local aaa authorization exec default local common voice-card 0 dspfarm dsp services dspfarm voice service voip fax protocol cisco modem passthrough nse codec g711ulaw modem relay latency 100 modem relay sprt v14 receive playback hold-time 35 interface Loopback1 description CME_Address ip address xxx.xxx.xxx.xxx 255.255.255.255 h323-gateway voip interface h323-gateway voip bind srcaddr xxx.xxx.xxx.xxx sccp local Loopback1 sccp ccm xxx.xxx.xxx.xxx identifier 1 version 3.1 sccp ! sccp ccm group 1 bind interface Loopback associate profile 1 register CME_DSP dspfarm profile 1 transcode codec g729abr8 codec g729ar8 codec g711alaw codec g711ulaw codec g729r8 maximum sessions 7 associate application SCCP control-plane voice-port 0/0/0 voice-port 0/0/1 no battery-reversal voice-port 0/0/2 voice-port 0/0/3 voice-port 0/1/0 voice-port 0/1/1 voice-port 0/1/2 voice-port 0/1/3 ip access-list extended VOIP-TCP permit tcp host XXX.XXX.XXX.67 any permit tcp any host XXX.XXX.XXX.67 permit tcp host 100.1.1.1 any permit tcp any host 100.1.1.1 ! ip access-list extended VOIP-UDP permit udp host XXX.XXX.XXX.67 any permit udp any host XXX.XXX.XXX.67 permit udp host 100.1.1.1 any permit udp any host 100.1.1.1 dial-peer voice 5139 pots description STE PSTN destination-pattern XXXXXX5139$ incoming called-number XXXXXX5139 port 0/0/0 _______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip _______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
