No, it's not, we cleared the pri-group's on both controllers by shutting down both voice-port and serial interfaces, removed the pri-group's, then added in correct config for NFAS.
Going to open a TAC case in a bit on it. On Mon, Dec 1, 2014 at 3:46 PM, Brian Meade <bmead...@vt.edu> wrote: > Is the pri-group already configured on that controller? If so, you'll > need to shut down the voice-port, the serial interface, and then do "no > pri-group" on the controller before re-defining the pri-group configuration. > > On Mon, Dec 1, 2014 at 5:37 PM, Charles Goldsmith <wo...@justfamily.org> > wrote: > >> We are seeing an odd error on a migration from a Nortel setup over to an >> h323 setup. >> >> the error message after entering PRI 2 is >> >> *crsvr1(config-controller)#pri-group timeslots 1-24 nfas_ backup nfas_int >> 1 nfas_group 1* >> >> *%The Primary-group is already defined* >> *%The first definition of the primary-group must be removed before the >> primary-group can be redefined* >> >> Getting this after putting the timeslots command on the first pri, then >> seeing this error on the 2nd controller. >> >> This is on 15.2 on a 3945. I've done this before with no issues, but >> have never seen this error before. >> >> Thanks >> >> >> _______________________________________________ >> cisco-voip mailing list >> cisco-voip@puck.nether.net >> https://puck.nether.net/mailman/listinfo/cisco-voip >> >> >
_______________________________________________ cisco-voip mailing list cisco-voip@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-voip