Is "Enable status poll" checked for the port on the MGCP device?
http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-communications-manager-callmanager/71647-busy-out-c-chan-ccm.html On 2015-02-03 10:43, Lelio Fulgenzi wrote:
double dang. not working. following notation examples. will see if existing TAC engineer can help. I like the idea of setting them to state "1", which sounds like it will busy them out after active calls are completed. Where x can be: 0 -- In service 1 -- Graceful out of service (Change channel status until active call ends if an active call exists on that channel.) 2 -- Forceful out of service (Tear down active call first; then, change channel status immediately if an active call exists on that channel.) --- Lelio Fulgenzi, B.A. Senior Analyst, Network Infrastructure Computing and Communications Services (CCS) University of Guelph 519‐824‐4120 Ext 56354 [email protected] www.uoguelph.ca/ccs Room 037, Animal Science and Nutrition Building Guelph, Ontario, N1G 2W1 ------------------------- FROM: "Lelio Fulgenzi" <[email protected]> TO: "Eric Pedersen" <[email protected]> CC: [email protected] SENT: Tuesday, February 3, 2015 11:28:10 AM SUBJECT: Re: [cisco-voip] easiest and quickest way to disable a PRI PSTN (MGCP) port? dang. not working for MGCP. will try CUCM service parameter. now to figure out the notation. --- Lelio Fulgenzi, B.A. Senior Analyst, Network Infrastructure Computing and Communications Services (CCS) University of Guelph 519‐824‐4120 Ext 56354 [email protected] www.uoguelph.ca/ccs Room 037, Animal Science and Nutrition Building Guelph, Ontario, N1G 2W1 ------------------------- FROM: "Eric Pedersen" <[email protected]> TO: "Lelio Fulgenzi" <[email protected]>, [email protected] CC: [email protected] SENT: Tuesday, February 3, 2015 11:13:25 AM SUBJECT: RE: [cisco-voip] easiest and quickest way to disable a PRI PSTN (MGCP) port? I thought that didn’t work with MGCP PRIs. Did that change? In the past I used the CUCM service parameter (Change B-Channel Maintenance Status) to busy them out. FROM: cisco-voip [mailto:[email protected]] ON BEHALF OF Lelio Fulgenzi SENT: 03 February 2015 8:42 AM TO: [email protected] CC: [email protected] SUBJECT: Re: [cisco-voip] easiest and quickest way to disable a PRI PSTN (MGCP) port? This is great. I like the idea of busy'ing out the channels. And I just tested it, it's additive, not destructive, so I can simply add busy channel statements and it groups them. Thanks everyone. Lelio --- Lelio Fulgenzi, B.A. Senior Analyst, Network Infrastructure Computing and Communications Services (CCS) University of Guelph 519‐824‐4120 Ext 56354 [email protected] www.uoguelph.ca/ccs [1] Room 037, Animal Science and Nutrition Building Guelph, Ontario, N1G 2W1 ------------------------- FROM: [email protected] TO: [email protected] SENT: Tuesday, February 3, 2015 9:54:48 AM SUBJECT: Re: [cisco-voip] easiest and quickest way to disable a PRI PSTN (MGCP) port? Assuming that you don't care about dropping any active calls: controller t1 X/X/X shutdown Otherwise, you could busy out the channels that are not in use (sh isdn service to see status). interface SerialX/X/X:23 isdn busy b_channel 0-24 On 2015-02-03 08:42, Lelio Fulgenzi wrote: > Good morning all, > > Here's hoping the snow is clearing up if that's what you had outside > your home/office these last few days! > > I'm looking for a quick way to disable a PRI PSTN (MGCP) port on my > 3945 gateway. I need to do some tests on a gateway in my local > building, but that means disabling the first outbound PSTN port on a > remote gateway. > > Normally I'd just unplug it, but there's just too much snow outside to > make the trek. ;) > > Thanks! > > Lelio > > --- > Lelio Fulgenzi, B.A. > Senior Analyst, Network Infrastructure > Computing and Communications Services (CCS) > University of Guelph > > 519‐824‐4120 Ext 56354 > [email protected] > www.uoguelph.ca/ccs [1] > Room 037, Animal Science and Nutrition Building > Guelph, Ontario, N1G 2W1 > > > _______________________________________________ > cisco-voip mailing list > [email protected] > https://puck.nether.net/mailman/listinfo/cisco-voip [2] _______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip [2] The contents of this message may contain confidential and/or privileged subject matter. If this message has been received in error, please contact the sender and delete all copies. Like other forms of communication, e-mail communications may be vulnerable to interception by unauthorized parties. If you do not wish us to communicate with you by e-mail, please notify us at your earliest convenience. In the absence of such notification, your consent is assumed. Should you choose to allow us to communicate by e-mail, we will not take any additional security measures (such as encryption) unless specifically requested. If you no longer wish to receive commercial messages, you can unsubscribe by accessing this link: http://www.bennettjones.com/unsubscribe _______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip Links: ------ [1] http://www.uoguelph.ca/ccs [2] https://puck.nether.net/mailman/listinfo/cisco-voip _______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
