My voice gateways currently have the following setup: ! voice-card 0 dspfarm dsp services dspfarm ! Now, from what I've read, the "dspfarm" command is used to invoke/enable DSP Sharing, which is strongly discouraged. And is typically used when sharing DSPs across voice cards and only for TDM ports. In my case, I have only VWIC3s along with an ISM running CUE installed in slot 0, the same as the DSPs (see below). >From what I gather, I don't need and should remove the "dspfarm" command from >my "voice-card 0" config. Is this correct? NAME: "VWIC3-4MFT-T1/E1 - 4-Port RJ-48 Multiflex Trunk - T1/E1 on Slot 0 SubSlot 0", DESCR: "VWIC3-4MFT-T1/E1 - 4-Port RJ-48 Multiflex Trunk - T1/E1" PID: VWIC3-4MFT-T1/E1 , VID: V01 , SN: <snip> NAME: "PVDM3 DSP DIMM with 64 Channels on Slot 0 SubSlot 4", DESCR: "PVDM3 DSP DIMM with 64 Channels" PID: PVDM3-64 , VID: V01 , SN: <snip> NAME: "Internal Services Module with Services Ready Engine on Slot 0", DESCR: "Internal Services Module with Services Ready Engine" PID: ISM-SRE-300-K9 , VID: V02 , SN: <snip> --- Lelio Fulgenzi, B.A. Senior Analyst, Network Infrastructure Computing and Communications Services (CCS) University of Guelph 519‐824‐4120 Ext 56354 [email protected] www.uoguelph.ca/ccs Room 037, Animal Science and Nutrition Building Guelph, Ontario, N1G 2W1
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
