Ahmed - Not sure if I completely follow but are you concerned about the order of operations for digit manipulation in IOS? If you are then I would say your expectation would be correct with digit manipulation in IOS occurring in the following steps and in the following order:
incoming voice-port incoming dial-peer num-exp outgoing dial-peer egress voice-port But after reading your email again it looks like you're more referring to the digit stripping that's inherent to POTS DPs... I'd have to test this to confirm but I would imagine the digit stripping would also occur first at the POTS outbound dial-peer level once matched, then voice translation would apply to the [potentially] stripped called party number. Are you saying the dial-peer digit stripping is occurring *after* the voice-port-level voice translation is applied? - Dan From: cisco-voip [mailto:[email protected]] On Behalf Of Ahmed Elnagar Sent: Wednesday, March 18, 2015 5:28 PM To: 'VOIP Group ' Cc: 'ahmed ellboudy' Subject: [cisco-voip] Translation Profile out on voice port Hi all; It has been a very long time since I posted to the mailing list but you are always the "gateway of last resort" to find an expert reply :) I was testing voice translation rules on a VGW with the below setup I want someone to be able to call extensions "1XXX" from a site connected back to back to another site using E1 0/3/0 "H323 GW with CUCM in each site"...I know I could do it with a simple forward-digits all under the pots dial-peer in order for the router to send 1XXX in the ISDN setup insetead of sending XXX. I am trying to verify the concept of translation profiles but I am having a strange issue, for the below call the pots dial-peer is matched as an outgoing dial-peer but as soon as this happens the debugs shows that the router check if there is a tx profile on the voice port "before making the digit strip" and translate the number and then make a dial-peer match again and then go out of the voice port...is that a normal behavior? My expectation is that the dial-peer should be matched first then apply digit strip and at the exit from the E1 interface translation profile to be applied. I cannot find any document that explains this part or document this approach...any ideas? Below is my configuration Voice translation rule 1 Rule 1 /^0../ /1\0/ Voice translation profile PSTN_OUT translate called 1 voice-port 0/3/0:15 translation-profile outgoing PSTN_OUT dial-peer voice 1 pots destination-pattern 1... port 0/3/0:15 Regards, Ahmed Elnagar | Networking Consultant | CCIE #24697, Voice [Description: Description: Description: Description: MS Green]
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
