For my own sanity.. can someone tell me if I'm correct on this; the username and password for registering a SIP line with a registrar should look like : ! sip-ua credentials number XXXXX username user1 password MyPassword realm MyRealm authentication username user1 password MyPassword !
Is there any where else it could pull the credentials from? Still getting 403 and SP still just says its a PW mismatch - but i'm just pasting in what they send me (checked for stray spaces and what-not already) Thanks! Ed On Wed, Jun 24, 2015 at 2:32 PM, Ed Leatherman <ealeather...@gmail.com> wrote: > Another one for posterity.. > > So it seems like SIP REGISTER requests are only shown using debug ccsip > noncall ... however there is no output from that command unless debug ccsip > messages is also running. very confusing when I only has debug noncall on > and didnt see any messages, but they were present in packet cap! > > On Wed, Jun 24, 2015 at 11:26 AM, Ed Leatherman <ealeather...@gmail.com> > wrote: > >> Following up for posterity.. >> >> Still fighting this one but a small bit of progress. So CME was trying to >> register both the ephone-dn extension and the E164 expanded number of the >> extension (which was the correct one) - so SP was putting us in timeout for >> trying to register invalid numbers. I figured out how to stop that with the >> number xxx no-reg command in each ephone-dn. >> >> Also, I had to re-write some headers in the REGISTER requests >> (to/from/request-uri and Authorization fields) with sip profiles. >> >> Also - as brian suggested, they told me the wrong username, should have >> not had dashes in it. >> >> After all that, still getting back 403 Authentication Failed - but its at >> least cleaned up and I'm not getting put in timeout. >> >> onward.. >> >> >> >> On Tue, Jun 23, 2015 at 6:06 PM, Ed Leatherman <ealeather...@gmail.com> >> wrote: >> >>> Didnt seem to help but thats a good thought. Slogging it out with SP >>> tomorrow again. I'm really puzzled about the SIP debugs.. its like i'm not >>> getting all my SIP messages in there >>> >>> On Tue, Jun 23, 2015 at 3:29 PM, Brian Meade <bmead...@vt.edu> wrote: >>> >>>> I'd try the username without the dashes first. >>>> >>>> On Tue, Jun 23, 2015 at 3:26 PM, Ed Leatherman <ealeather...@gmail.com> >>>> wrote: >>>> >>>>> I did a packet cap and we are sending the SIP REGISTER, but its not >>>>> showing up in sip debug?? really weird. anywhere I'm not binding SIP to my >>>>> loopback address, i'm not getting SIP debugs for. >>>>> >>>>> So I am getting 403 back from SP after all, gonna double check >>>>> username/passwords >>>>> >>>>> On Tue, Jun 23, 2015 at 3:16 PM, Brian Meade <bmead...@vt.edu> wrote: >>>>> >>>>>> How about connecting via telnet over 5060? You may be having a TCP >>>>>> issue which is why you never see the Register sent. >>>>>> >>>>>> On Tue, Jun 23, 2015 at 3:09 PM, Ed Leatherman < >>>>>> ealeather...@gmail.com> wrote: >>>>>> >>>>>>> Brian >>>>>>> msu-tmp-access#sho sip-ua register status >>>>>>> Line peer expires(sec) reg >>>>>>> survival P-Associ-URI >>>>>>> ================================ ========== ============ === >>>>>>> ======== ============ >>>>>>> 20311 20001 43 no normal >>>>>>> 20312 20003 43 no normal >>>>>>> 20313 20005 43 no normal >>>>>>> 20314 20007 43 no normal >>>>>>> >>>>>>> .. etc .. all no >>>>>>> >>>>>>> I can ping the sip-server from router so it appears to be able to >>>>>>> resolve the name OK. >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> On Tue, Jun 23, 2015 at 2:48 PM, Brian Meade <bmead...@vt.edu> >>>>>>> wrote: >>>>>>> >>>>>>>> What do you see for "show sip-ua register status"? Are you sure >>>>>>>> the gateway can resolve the sip-server via DNS? >>>>>>>> >>>>>>>> On Tue, Jun 23, 2015 at 2:32 PM, Ed Leatherman < >>>>>>>> ealeather...@gmail.com> wrote: >>>>>>>> >>>>>>>>> Hello! >>>>>>>>> >>>>>>>>> I'm trying to get a SIP trunk out to a regional SP (Lumos) >>>>>>>>> configured. I need to get CME setup to register numbers with their sip >>>>>>>>> proxy, but the registration is not happening and i'm not seeing any >>>>>>>>> register messages debugs from debug ccsip messages to troubleshoot >>>>>>>>> from. So >>>>>>>>> I think maybe CME isn't trying? What should trigger CME to try and >>>>>>>>> register >>>>>>>>> these numbers? >>>>>>>>> >>>>>>>>> My config looks like this (some ephones/ephone-dns up and >>>>>>>>> registered) - authentication credentials were provided from Lumos. IOS >>>>>>>>> 15.4(3)M2 >>>>>>>>> >>>>>>>>> msu-tmp-access#sh run | s sip-ua >>>>>>>>> sip-ua >>>>>>>>> credentials username 304-929-0300 password 7 blah realm >>>>>>>>> sbc.ia.ntelos.net >>>>>>>>> authentication username 304-929-0300 password 7 blah >>>>>>>>> retry register 10 >>>>>>>>> registrar dns:sbc.ia.ntelos.net:5060 expires 120 >>>>>>>>> sip-server dns:sbc.ia.ntelos.net:5060 >>>>>>>>> ! >>>>>>>>> msu-tmp-access#sho run | s voice service >>>>>>>>> voice service voip >>>>>>>>> ip address trusted list >>>>>>>>> ipv4 216.12.114.195 >>>>>>>>> address-hiding >>>>>>>>> allow-connections sip to sip >>>>>>>>> fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 >>>>>>>>> fallback none >>>>>>>>> sip >>>>>>>>> bind control source-interface GigabitEthernet0/2 >>>>>>>>> bind media source-interface GigabitEthernet0/2 >>>>>>>>> registrar server >>>>>>>>> options-ping 60 >>>>>>>>> >>>>>>>>> >>>>>>>>> >>>>>>>>> >>>>>>>>> >>>>>>>>> >>>>>>>>> >>>>>>>>> -- >>>>>>>>> Ed Leatherman >>>>>>>>> >>>>>>>>> _______________________________________________ >>>>>>>>> cisco-voip mailing list >>>>>>>>> cisco-voip@puck.nether.net >>>>>>>>> https://puck.nether.net/mailman/listinfo/cisco-voip >>>>>>>>> >>>>>>>>> >>>>>>>> >>>>>>> >>>>>>> >>>>>>> -- >>>>>>> Ed Leatherman >>>>>>> >>>>>> >>>>>> >>>>> >>>>> >>>>> -- >>>>> Ed Leatherman >>>>> >>>> >>>> >>> >>> >>> -- >>> Ed Leatherman >>> >> >> >> >> -- >> Ed Leatherman >> > > > > -- > Ed Leatherman > -- Ed Leatherman
_______________________________________________ cisco-voip mailing list cisco-voip@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-voip