The num-exp occur before the dial-peer match etc. You should have no issues using this.
However if CUCM and MGCP and using a Translation Pattern may break CTI Redirects. Gateway has to have direct reachability to CTI Route Point and CTI Port and Agent. You are not doing this. Can you dial 987 form a IP Phone to Trigger 987 ? Dialed Number Analyzer? In your script do you have a test prompt “You have reached a test prompt” ? before you attempt to invoke an Agent? Reading your question is somewhat confusing. Break your troubleshooting down step by step. Eg is CTI Route Point registered in CUCM, is correct IP? Have you tried a reactive script debug? From: cisco-voip [mailto:[email protected]] On Behalf Of Claiton Campos Sent: Thursday, July 16, 2015 12:55 PM To: [email protected]. Subject: [cisco-voip] Cisco UCCX with num-exp problem Does anyone know if there is any problem in using translation number with UCCX? For example, a costumer receives the last 4 digits of the operator and translates it into your gateway to a number of 3 digits using the num-exp, the setting he has is as follows: num-exp 1234 987 there is a dial-peer with destination- pattern 987 and session target <cucm_ip_address> on the gateway. In uccx there is a trigger with the number 987, however when a call is made it does not ring on the phone is just calling. itevomcid
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
