Some people claim it works okay with MGCP as long as you're on CUCM 8.x and higher above a certain IOS version. It's definitely easier to just switch to H.323 or SIP though.
On Wed, Feb 3, 2016 at 12:49 PM, Ryan Huff <[email protected]> wrote: > You'll need to CFG the gateway as h.323 (at least for that FXO port). CLID > doesn't work on FXO ports controlled by mgcpapp . You can run a "*debug > vpm port x/x/x*" and that should show the calling name received on the > FXO port, but if the port is under mgcpapp control, it won't pass the IE to > CCM. > > > Thanks, > > > = Ryan = > > > > Email: [email protected] > > Spark: [email protected] > > Twitter: @ryanthomashuff <http://twitter.com/ryanthomashuff> > > LinkedIn: ryanthomashuff <http://linkedin.com/in/ryanthomashuff> > > Web ryanthomashuff.com > > > ------------------------------ > *From:* cisco-voip <[email protected]> on behalf of > Brian Meade <[email protected]> > *Sent:* Wednesday, February 3, 2016 12:38 PM > *To:* David Zhars > *Cc:* [email protected] > *Subject:* Re: [cisco-voip] Caller ID issue > > What CUCM/IOS version? Do you have "Enable Caller ID" checked on the MGCP > FXO device? You should have "caller-id enable" under the voice-port on the > router. > > http://www.gossamer-threads.com/lists/cisco/voip/131620 > > On Wed, Feb 3, 2016 at 12:28 PM, David Zhars <[email protected]> wrote: > >> Sorry, just noticed in that example they reference ISDN. Again, calls >> coming in on ISDN are fine, we get name and number. >> It's when calls come in on the POTS lines that we just get the phone >> number. >> >> On Wed, Feb 3, 2016 at 12:27 PM, David Zhars <[email protected]> wrote: >> >>> ISDN works fine. It's when the calls come in on the POTS line. >>> >>> I did find this by googling: >>> >>> interface serialx/x/x:23 >>> isdn supp-service name calling >>> >>> I am not sure about the :23 after the serial port designation... >>> >>> >>> On Wed, Feb 3, 2016 at 12:23 PM, Brian Meade <[email protected]> wrote: >>> >>>> Does the carrier send the caller name in the ISDN Setup message or in a >>>> separate Facility message? Can you show "debug isdn q931" for one of these >>>> inbound calls? >>>> >>>> On Wed, Feb 3, 2016 at 12:13 PM, David Zhars <[email protected]> wrote: >>>> >>>>> Cisco UCM 8.0 with 2801 in MGCP mode. >>>>> Telco is sending Name and Number to us. >>>>> Phones only ever display Number. >>>>> >>>>> In UCM, selected phones have both Caller Name and Caller Number ticked. >>>>> >>>>> Anything else could be preventing us from getting Names? >>>>> >>>>> _______________________________________________ >>>>> cisco-voip mailing list >>>>> [email protected] >>>>> https://puck.nether.net/mailman/listinfo/cisco-voip >>>>> >>>>> >>>> >>> >> >
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
