With RFC2833, you're pretty much stuck with packet captures on the inside/outside of the CUBE assuming media flow-through.
On Wed, Mar 2, 2016 at 7:14 PM, Aaron Banks <[email protected]> wrote: > Yes, G.711 and both software and hardware resources. > > ------------------------------ > From: [email protected] > To: [email protected] > CC: [email protected] > Subject: Re: [cisco-voip] DTMF digits not hitting Voice Gateway > Date: Wed, 2 Mar 2016 23:25:02 +0000 > > > Do these phones have access to MTP resources and if so, software resources > or hardware resources? > > Also, I assume this is G.711, correct? > > Thanks, > > Ryan > > On Mar 2, 2016, at 4:40 PM, Aaron Banks <[email protected]> wrote: > > > > This problem has been resolved but I thought I'd put it out to the group > for feedback, suggestions or general discussion. > > One the odd occasion, this customer (who has 8861,8841,7821 SIP phones) > calls a business with an IVR and the DTMF digits don't work. It's odd (and > infrequent). The caller waits after pressing a digit and eventually the > call drops. > > My solution is to reset the SIP trunk between CUCM (v10.5.2) and CUBE. In > all instances, the issue is resolved. On the other side of the CUBE is > service provider SIP trunks. > > My question to the group is do any of you have the same issue with SIP > phones? If so, what do you do? > > Aaron > > _______________________________________________ > cisco-voip mailing list > [email protected] > https://puck.nether.net/mailman/listinfo/cisco-voip > > > _______________________________________________ > cisco-voip mailing list > [email protected] > https://puck.nether.net/mailman/listinfo/cisco-voip > >
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
